Cam Specs needed
07-13-2006, 08:26 PM
#2
Registered
iTrader: (1)
Re: Cam Specs needed
Why yes I do:
Mag BBC 454/502 Flat Tappet (rect heads)
.004” 296*, 296*
.006” 286*, 286*
.050” 224*, 224*
.200” 130*, 130*
Valve lift with 1.7 .510”, .510”
LSA 115.5
Part#431-9830
ICL 114 ATDC
ECL 117 BTDC
Part#431-850478 (same as above but ground with 5 degrees advance)
ICL 109 ATDC
ECL 122 BTDC
Mag BBC 454/502 Flat Tappet (rect heads)
.004” 296*, 296*
.006” 286*, 286*
.050” 224*, 224*
.200” 130*, 130*
Valve lift with 1.7 .510”, .510”
LSA 115.5
Part#431-9830
ICL 114 ATDC
ECL 117 BTDC
Part#431-850478 (same as above but ground with 5 degrees advance)
ICL 109 ATDC
ECL 122 BTDC
07-13-2006, 08:29 PM
#3
Registered
iTrader: (1)
Re: Cam Specs needed
I forgot to add, the 90-92 502 Mag used #431-9830. See above. This is according to BAM's website look up tables.
07-13-2006, 09:44 PM
#4
Registered
Thread Starter
Re: Cam Specs needed
Originally Posted by SB
I forgot to add, the 90-92 502 Mag used #431-9830. See above. This is according to BAM's website look up tables.
Nordic95
