JimV

iTrader: (1)

Hey Guy's Im looking for a PTO flange for a stellings stand off box. Merc uses them for triple engine application center motor drive shaft. Anyone know where I can get one? [ATTACH=CONFIG]544006[/ATTACH] Im looking for the center hub

MILD THUNDER

iTrader: (3)

Maybe this will help ya Jim. Also, might be worth a post in the wanted section, maybe someone has one laying around

http://www.mercruiserparts.com/Show_...TS+%28BRAVO%29

JimV

iTrader: (1)

Holy crap that's expensive. Thanks

airjunky

iTrader: (2)

I believe i have one . Attaches to about a 5'or6' driveshaft. May need the id measurement of the inner centering flange of the u joint hub from your driveshaft .

Griff

I was surfing last night and Shogren has a couple used ones in their parts section.

JimV

iTrader: (1)

Thanks

mrquad1

just a little info the merc carriers use concave washers and the stellings carriers use a flat surface,also you will need the correct shim washers to align for input shaft on gimble shaft from drive

JimV

iTrader: (1)

PM sent

JimV

iTrader: (1)

Mine would be the merc carrier then. It has the concave washers I bought the box used with an adjustable jack bolt and the box is slotted. It is a stellings box unless merc got theres from stelling Thanks Jim