replacing cap and rotor - ignition module ?
#1
Registered
Gold Member
Thread Starter
Join Date: Oct 2009
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
replacing cap and rotor - ignition module ?
Im replacing the cap and rotor on my 1995 502 efi. The ignition module looks a little shabby so I want to replace it. Its a 8 pin module. The number on top says 369 1k12 GM. On the bottom 369a 7900-01. Singapore. My question is what brand or part number can I replace it with. Any info would be appricated . Thank You
#2
Registered
iTrader: (1)
Delco 1965A
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
#4
Registered
iTrader: (2)
Delco 1965A
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.