replacing cap and rotor - ignition module ?
04-15-2016 | 04:51 PM
#1
Thread Starter
Registered
Joined: Oct 2009
Posts: 108
Likes: 0
replacing cap and rotor - ignition module ?
Im replacing the cap and rotor on my 1995 502 efi. The ignition module looks a little shabby so I want to replace it. Its a 8 pin module. The number on top says 369 1k12 GM. On the bottom 369a 7900-01. Singapore. My question is what brand or part number can I replace it with. Any info would be appricated . Thank You
04-15-2016 | 05:10 PM
#2
Registered
Joined: Nov 2004
Posts: 14,100
Likes: 3,687
From: On A Dirt Floor
Delco 1965A
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
04-16-2016 | 12:49 AM
#4
Registered
Joined: Aug 2011
Posts: 2,733
Likes: 8
From: bel air, md
Delco 1965A
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
Usually cheaper on Amazon, than local.
Make sure you get good heatsink paste. They usually don't come with the module and good luck getting real stuff locally. If anyone carries it, it will be dielectric grease disguised as heat sink paste.
They sell Arctic Silver heatsink paste on Amazon too.
