Out There

These rams were on my boat when I bought it. I'm not sure who makes them and I want to rebuild them. Can anyone tell me who the manufacturer was/ is? Any help is appreciated. Also, if you have suggestions on who to send them to for a rebuild would be great.
Thanks!

BoatShow239

...getting a scale on them.

They appear to be a threaded cylinder and not a welded one, so I would think any equipment hyraulic shoppe in the area would be able to accomidate what you need.

Granted most of them work on slightly larger rams from things like a Cat D9 dozer, but I am sure they can either take care of your issue or send you in the correct direction.

Are they about 16" closed?

tomcei

I have been told they were Hardin marine. I did take them to a local shop, Thanks

ChrisK

And hydraulic cylinder repair place can fix them. Simple single ram cylinder.

commandersander

iTrader: (8)

Look for a Miller Bearing local to you. There used to be a place in cumming that I used, but that is back when Lanier athletic center was the size of a car wash and blacks were afraid to be in town

ChrisK

Miller bearing does not rebuild cyclinders... We have one local here, as well as in Daytona, etc... They have a ton of stuff, but dont do that.

commandersander

iTrader: (8)

But they do have the wipes, seals and retainers

DirtyMoney

Call Fluid Power 770-532-0444 and take them to Ron. If they cant figure it out nobody locally can. They are in gainesville off of hwy 60

tomcei

Thanks guys the picks were put up for me. I'm get'n r' done