Oil cooler with oil in and out at same end
#1
Charter Member #139 /Moderator/Platinum Member
Charter Member
Thread Starter
Join Date: Nov 2000
Location: McHenry IL /Duck Key FL
Posts: 2,201
Likes: 0
Received 0 Likes
on
0 Posts
Oil cooler with oil in and out at same end
I am looking to go to a larger cooler on my carbed 500hps and would also like to clean up the plumbing a bit and think that if there was a cooler with in and out at same end thh oil line could be a straight shot from the themostatic oil filter mount verus one having to have a big loop in it which is tough with the braided oil lines.
who makes one and any picture of neatified plumbing would be appreciated
who makes one and any picture of neatified plumbing would be appreciated
#3
~~~~
Charter Member
Re: Oil cooler with oil in and out at same end
You would want a "two pass" cooler. Teague sells one.
You could make Klaw's into a two pass. You will have to loop two of the fittings, on one end..
You could make Klaw's into a two pass. You will have to loop two of the fittings, on one end..
Last edited by RLW; 05-12-2006 at 04:36 PM.
#4
I hate the winter!!
Platinum Member
Join Date: Jul 2001
Location: long island, new york
Posts: 2,707
Likes: 0
Received 0 Likes
on
0 Posts
Re: Oil cooler with oil in and out at same end
Hey Russ,
Just a quick update on my new oiling system. While I have only got to run the boat once this year, the system seems to work great. Temps are a bit low, but I equate that to cold air, cold water and not beating it up too badly yet. I am still taking it easy on my freshly rebuilt drive. I'll keep you posted.
Vinny
Just a quick update on my new oiling system. While I have only got to run the boat once this year, the system seems to work great. Temps are a bit low, but I equate that to cold air, cold water and not beating it up too badly yet. I am still taking it easy on my freshly rebuilt drive. I'll keep you posted.
Vinny
#5
SORE MEMBER
Platinum Member
Join Date: Apr 2004
Location: 29°50'49.74"N 95° 5'17.55"W.......TEXAS
Posts: 6,989
Likes: 0
Received 1 Like
on
1 Post
Re: Oil cooler with oil in and out at same end
Teaugue's offshore 2 pass cooler has the water inlet and outlet at the same end, however the oil in and oil out are about 12" apart
Thread
Thread Starter
Forum
Replies
Last Post
t500hps
General Boating Discussion
5
07-17-2012 09:23 AM