Has anyone here tried Arneson Rocker Plates?
#1
Charter Member #927
Charter Member
Thread Starter
Has anyone here tried Arneson Rocker Plates?
http://www.arneson-industries.com/Ar...r%20Plates.htm
These look very intresting. My 34' Super Hawaii has a 25* V and a notched transome. I put a mark on my trim indicators where my prop shaft is parallel to the bottom ( prop shaft isabout 4" below the bottom). The mark is at #4. I can only trim up to about 2.5 and I start to porpus. It will go away if I drop the tabs below level with the bottom. But, I feel like I am scrubbing off speed if I do this because I really don't speed up any with more trim.
My prop slip is 7-8% so that is very good.
These look very intresting. My 34' Super Hawaii has a 25* V and a notched transome. I put a mark on my trim indicators where my prop shaft is parallel to the bottom ( prop shaft isabout 4" below the bottom). The mark is at #4. I can only trim up to about 2.5 and I start to porpus. It will go away if I drop the tabs below level with the bottom. But, I feel like I am scrubbing off speed if I do this because I really don't speed up any with more trim.
My prop slip is 7-8% so that is very good.