Need-the-Speed

Scenerio:
Engines running great with full power. After a short time oil starts "oozing" out dipstick tube. Why?

ROB FREEMAN

iTrader: (2)

blowby , or poor crank ventalation , check youre breathers or pcv valve see if operating properly

Vinny P

Possibly too much oil or bad windage. Maybe the crank is whipping it up and pushing it out the tube.

Need-the-Speed

Motor has good compression. It was recently freshend up. The line checked. I will replace the valve.

Need-the-Speed

I changed oil and made sure level was correct. As far as the crank.....It's been running fine for several years.

ROB FREEMAN

iTrader: (2)

motor will can still have good cranking compression and still have enough blowby to push dipstick out , best bet is to run a leakdown and go from there , on my 598 my ring gap is a little loose and i get a little dipstick pressure / blowby / but its better loose than sticking a piston . rob

Griff

Do you have vents coming off your valve covers????

Smitty

iTrader: (1)

is it a blower motor?

Need-the-Speed

Yes vents off the valve covers.
Yes it's a blower motor....merc. 575.

320es

575 in a 24cs? That has got too be a screamer.