cyrus77

iTrader: (4)

New transom, what angle to drill Drive trim indicator cables?
ON a 33 AVS 2000. It has little chrome cover where they passed through. I did not not the angle of the cables before I replace the transom.

Thanks

Blueabyss

Same angle as transom.

https://www.harborfreight.com/angle-...ide-95622.html

Crude Intentions

iTrader: (1)

Order these. Mount on transom and use as a jig. Very nice and clean.

Stainless Cable Thru-Hull Fitting, 45 Deg - CP Performance

Wildman_grafix

that's what I did and cut the angle it is.

Clean install.

cyrus77

iTrader: (4)

So it is not the same as the transom. But the drill attachment is grteat.
The angle fittings are nice. and they are about 45 degrees right. Really nice looking! it says 1/2 inch I though the cables were smaller than that?

Crude Intentions

iTrader: (1)

They have gaskets in them. Once the cable is through you install a rubber seal then a plastic piece then tighten down.