500efi,where To Tap In For Water?
#1
Registered
Thread Starter
500efi,where To Tap In For Water?
I need to tap into the cooling system for a water supply for my drive shower. My new blackhawk will run too high to give a reliable source of cooling water. Where is the best place to tap into the water system?
Last edited by Airpacker; 04-07-2003 at 04:36 PM.
#2
Official OSO boat whore
Charter Member
iTrader: (2)
Join Date: Oct 2000
Location: Mequon, WI
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
I tapped into my oil cooler. The ends of the cooler were heavy brass castings. I drilled and tapped it for 3/8" pipe and then ran a line over to the transom. I also added a ball valve so I wouldn't waste water when I was on the hose.