Von Bongo

Where in the heck can I get the little nylon or plastic compression washers for the hook up for my water pressure fitting on the engine block?

I can't find them at west or eddie or anywhere. It's a small hose and the setup screws into the block and has a small fitting that the hose fits on, then a compression washer and then a nut with the center cut out for the hose goes over it.

This is driving me nuts I need 1 but I would like to get a bunch, The fitting that the hose goes to has no barbs.

help if you can.

Thanks
Mike

later

Mike,
Are you sure its not a flaired fitting with no washers needed?

I'm planning on being in the water next weekend you going to be out?

later
Dave

Von Bongo

Hi Dave,

No the fitting is strait, no flare and no barbs. Althouhg I could replace it with such if I could find one of those.

Next weekend I am going to Dallas to see the neck car race. Friend has rented a condo that overlooks track. It's half condo and half skybox so I am pretty pumped. But I will be out the following weekend if I can find the part I need

Griff

Von, try some of the local hardware stores. I know Westlake carries a lot of that of that stuff.

Reed Jensen

if all else fails... you can order a million of them from www.bokers.com........

Liberator21

Check out the auto parts stores. Those same parts are used on the air hose for the Hadley air horns. Hadley sells them in a bag as replacement parts. I have a bag of them out in my garage somewhere. They've saved my a$$ on quite a few jobs.