Eickert exhaust hole location
#1
Guest
Posts: n/a
Eickert exhaust hole location
600 volvo with Eickert headers and thru hull tailpipes mated to a bravo setup. I have this diagram of the dimentions, but cannout get the actual cutout locations.
Eickert couldnt verify if it was a std bravo cutout, and had me contact innovation who had the same info as Eickert. The engine and transom are not in yet and I would like to do this prior to the install. Who is good with geometry.......I only want to cut once
Eickert couldnt verify if it was a std bravo cutout, and had me contact innovation who had the same info as Eickert. The engine and transom are not in yet and I would like to do this prior to the install. Who is good with geometry.......I only want to cut once
#4
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
Re: Eickert exhaust hole location
I just installed two set and they did hit the standard bravo cutouts. They weren't perfect, but close enough for the rubber connection to compensate. I run edelbrock aluminum heads so that might have been why they did not hit exact. They were about a 1/4" low all the way around, which isn't bad.
BT
BT
Thread
Thread Starter
Forum
Replies
Last Post
Dave1972
General Boating Discussion
1
07-10-2002 05:17 PM