Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Reckless32
Showing results 1 to 22 of 22
Search took 0.00 seconds.
Forum: General Q & A
06-12-2007, 12:12 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Ed yeah i know. Just wasn't expecting a 9 hour...

Ed yeah i know. Just wasn't expecting a 9 hour difference in key time.

Well this past weekend I took the boat out overnight to Norfolk's Harborfest. The 2 beeps per minute alarm returned, though...
Forum: General Q & A
06-08-2007, 08:05 AM
Replies: 54
Views: 24,625
Posted By Reckless32

Dave good question. I'm gonna be keeping my eye...

Dave good question. I'm gonna be keeping my eye on them and sniffing for any future heated plastic odors in case there's something lingering.

Rage does it screw into the same housing as the...
Forum: General Q & A
06-07-2007, 12:29 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Are you referring to the water separator?

Are you referring to the water separator?
Forum: General Q & A
06-07-2007, 11:34 AM
Replies: 54
Views: 24,625
Posted By Reckless32

I had fuel issues last year after the state went...

I had fuel issues last year after the state went to Ethanol May 1st 2006. I suspect the tank had some water in there, and consequently when Ethanol was added it slowly went to crap. Went thru a boost...
Forum: General Q & A
06-05-2007, 09:32 PM
Replies: 54
Views: 24,625
Posted By Reckless32

The main pump on the port side is almost...

The main pump on the port side is almost impossible to get to.

I changed th IAC today and eliminated the alarm. Real test will be when the rubber hits the road....:rolleyes:
Forum: General Q & A
06-05-2007, 01:49 PM
Replies: 54
Views: 24,625
Posted By Reckless32

It's called good old fashioned perseverence...

It's called good old fashioned perseverence Bill...:et:

Ed it wasn't ignored, just couldn't be proven at the time until after i got the scantool in hand and THEN was able to isolate it. Otherwise...
Forum: General Q & A
06-04-2007, 11:21 AM
Replies: 54
Views: 24,625
Posted By Reckless32

While on the subject of running individual tests,...

While on the subject of running individual tests, to do an injector test it says to unplug/disable the fuel pump. Does that mean only the boost, or both pumps port & starboard?

I have found and...
Forum: General Q & A
06-04-2007, 11:17 AM
Replies: 54
Views: 24,625
Posted By Reckless32

The usuals plus overspeed, guardian, and yes the...

The usuals plus overspeed, guardian, and yes the IAC. But I had gone thru a remove, clean, replace cycle in the beginning in addition to re-positioning the T-fittings, and the IAC code never appeared...
Forum: General Q & A
06-03-2007, 01:13 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Reflecting back it seems I did for a brief moment...

Reflecting back it seems I did for a brief moment messing around under the hatch smell a faint odor of burnt plastic or something, and even made a quick look around both motors, and found nothing...
Forum: General Q & A
06-02-2007, 10:49 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Got a IAC Output fault today on the scantool....

Got a IAC Output fault today on the scantool. Actually got it once before, erased and it didn't pop back up. Took it off after my test run today, and it was "charred" around the bottom of the...
Forum: General Q & A
06-02-2007, 11:22 AM
Replies: 54
Views: 24,625
Posted By Reckless32

Well I fouind out thru searching the forum that...

Well I fouind out thru searching the forum that the Fuel LVL/LVL2 codes are like the Pitot/Steer codes, they will always be there looking for options that the Smartcraft DTS can use and therefore are...
Forum: General Q & A
06-02-2007, 10:35 AM
Replies: 54
Views: 24,625
Posted By Reckless32

Well I got one motor to stop the double-beeping...

Well I got one motor to stop the double-beeping and run fine by rotating the T more in a downward direction. The other has reduced to intermittent. I lowered the T angle as much as I could yesterday...
Forum: General Q & A
05-24-2007, 01:00 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Thanks guys for advice. I finally got my lift...

Thanks guys for advice. I finally got my lift motor changed and the boat on the lift yesterday. I plan on diving into the mystery a little later on. I'll definitely be taking what's said while deep...
Forum: General Q & A
05-23-2007, 01:54 PM
Replies: 54
Views: 24,625
Posted By Reckless32

The flush lines with the Perko cap on tight, and...

The flush lines with the Perko cap on tight, and the Y valves closed is air tight. But there may be just enough from the void in the line via vacume to cause some aeration "in theory". I'm going to...
Forum: General Q & A
05-23-2007, 12:47 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Yeah, this past winter put a hurtin' on the...

Yeah, this past winter put a hurtin' on the hardware. Got most of it cleaned up while it was apart and painted. Problem always is the bilge holds so much stagnant moisture.

The PVC does have...
Forum: General Q & A
05-23-2007, 10:43 AM
Replies: 54
Views: 24,625
Posted By Reckless32

Makes sense to me, but it would seem to me to...

Makes sense to me, but it would seem to me to only have affect when flushing? When I op-checked it by flushing the weekend before there was no alrms and everyhting worked great. I simply did what a...
Forum: General Q & A
05-23-2007, 09:28 AM
Replies: 54
Views: 24,625
Posted By Reckless32

I'm pretty sure i didn't do any damage to the...

I'm pretty sure i didn't do any damage to the sensors as it was no different than changing out the impeller for me.

Definitely no spring loaded Perko kit with the spring to rust out. Just...
Forum: General Q & A
05-22-2007, 05:11 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Well good, bad, or indifferent, I just ordered...

Well good, bad, or indifferent, I just ordered the Merc scantool from Rinda to be received by Friday. I'm tired of having these little grimlins and not get immediate satisfaction as to what my...
Forum: General Q & A
05-22-2007, 02:48 PM
Replies: 54
Views: 24,625
Posted By Reckless32

Thinking out loud again...if the...

Thinking out loud again...if the coolant/anti-freeze was low, would it give a similar alarm sequnce? If so, how low does anyone think it would have to be before it kicked in? Mine is a tad low from...
Forum: General Q & A
05-22-2007, 02:39 PM
Replies: 54
Views: 24,625
Posted By Reckless32

There's actually another local single 496HO (we...

There's actually another local single 496HO (we just spoke on the phone) who i found out has been having the same exact symptoms/problem since installing his Perko version of the flush kit, only his...
Forum: General Q & A
05-22-2007, 01:10 PM
Replies: 54
Views: 24,625
Posted By Reckless32

That's some pretty logical thinking. I know I'm...

That's some pretty logical thinking. I know I'm not the only guy who has installed a fresh water flush t-fitting in the raw water feed hose, and I know the hoses themselves are closed off with...
Forum: General Q & A
05-22-2007, 10:03 AM
Replies: 54
Views: 24,625
Posted By Reckless32

496HO Beep-Beep alarm....then

Out of the blue during Saturday's OM Poker Run after purring like a kitten a couple of weeks before, I start my motors and start getting this annoying double-beep alarm every 30-45 seconds all day...
Showing results 1 to 22 of 22


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.