Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Raylar
Showing results 1 to 11 of 11
Search took 0.00 seconds.
Forum: General Q & A
12-23-2009, 01:54 AM
Replies: 149
Views: 41,456
Posted By Raylar

Wink If it were my boat and it sat on a lift over the...

If it were my boat and it sat on a lift over the water for a few months or so, fresh or salt, and it had stock iron heads I would leave the turbulators in.
Get our Raylar aluminum heads with our...
Forum: General Q & A
12-20-2009, 02:56 PM
Replies: 149
Views: 41,456
Posted By Raylar

Wink What is a turulator??

No, thats correct, turbulators are there to collect condensation and burn it off when the engine is restarted.

A boat slipped or stored over water, especially around salt water where the...
Forum: General Q & A
12-15-2009, 11:22 PM
Replies: 149
Views: 41,456
Posted By Raylar

Smile Different engine packages can use different header units

Imco's Powerflow manifold and riser combination with the seperate exhaust ports in the riser are a very good manifold design and should be similar in power to the Dana and CMI sporttubes in power...
Forum: General Q & A
12-15-2009, 10:51 AM
Replies: 149
Views: 41,456
Posted By Raylar

Wink Yes, whenever a true set of headers or header...

Yes, whenever a true set of headers or header manifolds is installed on a 2004 or newer 496 MAG or HO engine the air fuel ratios should be rechecked if possible at full throttle, if not at least...
Forum: General Q & A
06-09-2007, 12:20 PM
Replies: 149
Views: 41,456
Posted By Raylar

Unhappy Sorry guys, just discovered through your comments...

Sorry guys, just discovered through your comments that our Webmaster made some pricing mistakes when updating the website. Our truck kits like the 101 and 102 should be shown as 3840.00 each and the...
Forum: General Q & A
06-04-2007, 10:39 PM
Replies: 149
Views: 41,456
Posted By Raylar

Question Not sure what you mean exactly, give me an...

Not sure what you mean exactly, give me an example.

Regards,
Ray @ Raylar
Forum: General Q & A
06-04-2007, 08:47 AM
Replies: 149
Views: 41,456
Posted By Raylar

Wink It varies with rpm and load but at WOT I like to...

It varies with rpm and load but at WOT I like to see it at 13.0 to 13.2 EFI only. For those who are supercharged don't use these figures!!
Forum: General Q & A
06-01-2007, 09:20 AM
Replies: 149
Views: 41,456
Posted By Raylar

Wink At a point where the EGT's get so hot that the...

At a point where the EGT's get so hot that the pistons and exhaust valves will start to burn with sustained rpm and load, Hot Tip! Don't go there!

Ray @ Raylar
Forum: General Q & A
05-28-2007, 10:10 PM
Replies: 149
Views: 41,456
Posted By Raylar

Wink NO Best Regards, Ray @ Raylar

NO

Best Regards,
Ray @ Raylar
Forum: General Q & A
04-24-2007, 05:10 PM
Replies: 149
Views: 41,456
Posted By Raylar

Wink Thought I would bust another myth here in this...

Thought I would bust another myth here in this thread since it was mentioned. GM has no current plans to drop the 496 8.1L engine for the Marine or other non light truck uses. That information comes...
Forum: General Q & A
04-23-2007, 10:07 AM
Replies: 149
Views: 41,456
Posted By Raylar

Smile Bob: Very interesting results, especialy the...

Bob:

Very interesting results, especialy the effects of water in the exhaust and the loss of power through the Bravo drive. As for the exhaust results I can say that all ofour dyno testing was...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.