Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: fund razor
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Forum: General Q & A
05-21-2004, 11:27 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

The pin is toward the transom and the bolt with a nylock is farther from the transom but they line up with each other in a front to rear orientation.
Forum: General Q & A
05-21-2004, 11:24 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

P Offshore....

I never saw the bar or the joint/bracket on the bar (was missing when I bought boat) but your description would have to be the way it was.

What you describe would fit what I have...
Forum: General Q & A
05-20-2004, 09:12 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

My guess is that the bar went across the "top" so to speak, with the bracket coming in from the side over the top of the pin and the stud.

There's no room below. It would hit the ram arm end.
Forum: General Q & A
05-20-2004, 09:10 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

here's a different pic.
Forum: General Q & A
05-20-2004, 08:10 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

The distance from center of pin/stud is 21 3/8" without touching anything. There is enough play to easily push both drives toward each other 1/16 of an inch to make an exact 21" between the center,...
Forum: General Q & A
05-20-2004, 08:04 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

Ok, sorry it took a couple days. This is my busy season,even if I didn't have boats.

Here's the bracket:
Forum: General Q & A
05-18-2004, 09:52 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

Roger that Jon, thanks.
Forum: General Q & A
05-18-2004, 07:41 AM
Replies: 16
Views: 1,508
Posted By fund razor

Re: Searching for Tie Bar for drives

The one with the OMCs is a Chris Craft Stinger 260.

When I had time to take a pic it was pouring.

I might fall back on making one up.
I know what S/S heim joints are...What's "CP"?

Thanks.
Forum: General Q & A
05-17-2004, 12:51 PM
Replies: 16
Views: 1,508
Posted By fund razor

Searching for Tie Bar for drives

Currently looking for a 21" tie bar to connect OMC cobra drives. Boat still has (intact) brackets on inner drive trim ram ends. Would like to replace missing bar.

Checked Eddie Marine (overkill,...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.