Mercruiser/Gil Manifolds Cheap, need some work
02-07-2012, 06:01 PM
#1
Mercruiser/Gil Manifolds Cheap, need some work
I have a set of Mercruiser/Gil Manifolds, they were pressure tested ok and then sent out to be sand blasted.
After all the powder coat was off there is alot of pitting showing on them. 1 cylinder on 1 manifold will need epoxy in my mind but did seal fine as is.
One riser stud hole needs tap.....
Like I said, these need some work but pressure tested ok so are still useable for a budget or spares???
And again, cheap cheap cheap!!!!
$150 + ship
pics coming......
After all the powder coat was off there is alot of pitting showing on them. 1 cylinder on 1 manifold will need epoxy in my mind but did seal fine as is.
One riser stud hole needs tap.....
Like I said, these need some work but pressure tested ok so are still useable for a budget or spares???
And again, cheap cheap cheap!!!!
$150 + ship
pics coming......
02-09-2012, 08:43 AM
#4
Registered
Join Date: Sep 2011
Location: Buffalo, N.Y.
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Gold Member
