Velocity Vector

iTrader: (4)

Last I heard Bob had thanksgiving dinner on top flame arestors.

stimleck

Does anyone know if the boat is complete?

SB

iTrader: (1)

Maybe he and the boat accelerated past light speed, entered a time warp, and he's out kicking some 70's/80's performance boat azz. LOL.

hogie roll

I used one of them calculators to determine that this boat can go 145mph. Yup

notda1

I expect a min 120 , hope maybe into the 130's ?

Velocity Vector

iTrader: (4)

Ray I really don't think it will take 120 minutes to get to 130 MPH. What calculator are you using or better yet share some of what your taking.

Coolerman

Just make sure they are hering props and blueprinted skegs at those speeds in a vee bottom!

EXCESS ENERGY

iTrader: (2)

Ok guys, here's the deal. We installed motors on Sept. 27. A couple weeks I had just about everything hooked up. Went to install the new headers CMI sent me 4 years ago and low and behold they DON"T ****ING FIT..........**** ME.... The two in the center are too wide and don't fit. They bolt up but can't get the second header in...Nothing on my end has changed. We are negotiating with CMI to get this issue resolved ASAP LOL. CMI did not copy my old headers and tails and not having motors in boat when we received them we didn't know they wouldn't fit. Bob.

Unlimited jd

iTrader: (5)

They should have known how wide the engines would be with them bolted on, no? Obviously if that measurement is more than your drive center center it's nfg. I'm sure you looked into every option. Maybe you'll have to stagger it! Good luck

EXCESS ENERGY

iTrader: (2)

CMI had all the info plus my old headers and tails. All they had to do was copy them. They elected to do it their way, so here we are now......