tomcei

As i look thru my pics i realize the sequence of events are a bit jacked up. Phone swaps and gallery folders are killing me...lol. I am trying not to jump around with what im showing but the work i did and the ADHD in me is all over the place. When one part doesn't show up or fit im on to the next item i can tackle. Hence ,.....now the whole boat is blown apart...

tomcei

Started modification on windscreen and hatch

Uremoved the tie in on the hatch where canopies tappered back. Looked killer with canopies but not so much without




Getting closer

tomcei

Nice and slick

Better looking profile imho

tomcei

So at this point I'm good with the over all lines of the boat. Blacking out the windscreen helped. I am working on some little nick knack pieces for the vent holes and still cleaning up the interior, we'll actually stripping and cleaning out the interior. I'll post pics of the stripped out dash and floor soon. I'm also still assembling powder coated hardware in the bilge. I went round and round with some used mtrs and took a bath on that deal. I've licked my wounds and Finally broke down and decided to go with some ultra tall Dart blocks and Heads. Building 632 NA to run on 89/90 pump gas.

tomcei

Template over New flooring

After stripping i Coated with imron

Popped in a mechanical heads up ,

Rebuilt the shifter assmy. Ended up changing color to black

Bling for the vent.. had a local shop cnc this for me from a template i made

Rebuilding the seat bases for correct height and slight recline to work with the new seats

Had to mark cut and reweld the mounts.. i will powder coat black

Newly assembled with color change

Interior goodies.

Made some foot rests

Trimmed them out with flooring to match

Mocking up some grab handles for the front seats.. wanted something to hold on to while adjusti trim and tabs.. i will cover the handles with rubber and dress them up. White board is the backing for the new upholstery

Twin O/B Sonic

Way cool project!

Thanks for taking the time to post the progress.

BTW, on the motors, as highly loaded and strung as they will be, I’d spend every dime you can on them!

tomcei

Thanks..story of my life.. spending more than I should.. more misc interior pics..

Finished my front seat grab handles

Trimmer out the switches


Going with a carbon Fiber dash

Seats are done..also covered the console to match

tomcei

Side panels done

Went nuts with ideas playing with switch layout

Dash template



All holes drilled finally... measured a dozen times on each cut

Starting to come together

tomcei

Cleaned up a lottle..i made a trim molding out of aluminum and powder coated it black for the console base.. this will tue in with the seat bases.

Foot rests in place

tomcei

Seat base.