selling my 32' A/T...
01-19-2010 | 07:13 PM
#11
Registered
Joined: Jul 2002
Posts: 2,233
Likes: 1
From: pa
These engines are going in my 32' AT that is up for sale....and were built by Dave Wesseldyk at WESCO in Jension, MI just outside of Grand Rapids.
New blocks, 4.24", new rotating assemblies, rings, bearings, stainless valves, Isky valve springs, 10* retainers/locks, hydraulic cams/lifters, Intake manifolds, Stainless steel 1.7 roller rocker arms, pushrods, balancers, oil pumps, Roll Master timging chain sets, new Glenwood Marine timing chain covers and pumps....most all internal components are new.
Engines dyno'd at 509hp and 561tq....
New blocks, 4.24", new rotating assemblies, rings, bearings, stainless valves, Isky valve springs, 10* retainers/locks, hydraulic cams/lifters, Intake manifolds, Stainless steel 1.7 roller rocker arms, pushrods, balancers, oil pumps, Roll Master timging chain sets, new Glenwood Marine timing chain covers and pumps....most all internal components are new.
Engines dyno'd at 509hp and 561tq....
01-19-2010 | 08:59 PM
#16
Thread Starter
Registered
Joined: Oct 2000
Posts: 4,541
Likes: 107
From: Western Michigan
I wish this video was longer but it's still kinda cool. Hope to see you in something new soon. Kris.
http://www.youtube.com/watch?v=VA4IbuNL3kM&sns=em
http://www.youtube.com/watch?v=VA4IbuNL3kM&sns=em
01-20-2010 | 08:52 PM
#17
Registered
Joined: Jul 2002
Posts: 2,233
Likes: 1
From: pa
I wish this video was longer but it's still kinda cool. Hope to see you in something new soon. Kris.
http://www.youtube.com/watch?v=VA4IbuNL3kM&sns=em
http://www.youtube.com/watch?v=VA4IbuNL3kM&sns=em
02-05-2010 | 12:19 AM
#19
Thread Starter
Registered
Joined: Oct 2000
Posts: 4,541
Likes: 107
From: Western Michigan
The 482's both dyno'd at 509hp each---I'm thinking it should push the boat at about the 80mph mark or so. I told Dave to build the engines to make 500hp....so they are very mildly cammed for a 482cid engine.
