Originally Posted by camptappakeg69
(Post 3837826)
Wow that huffer is a tight fit! looking good!
Thanks, its a pain getting in there to clean. But looks so damn good when clean. I polished a bunch of aluminum including the blower, should look sharp when I put it back in
laszlo01
12-26-2012 07:45 PM
Huffer and engine package is looking nice...
R Addiction
12-26-2012 07:57 PM
MGH, I know its out there somewhere but how fast is your Tantrum? HP?
mgh
12-26-2012 08:29 PM
Originally Posted by R Addiction
(Post 3838230)
MGH, I know its out there somewhere but how fast is your Tantrum? HP?
This past year I had it up to 84mph on GPS and got out of it, think I could of got a little more air under the boat but started to get squirly. The engine is a 500hp (from what I was told all stock internals) with aluminum heads and PSI on the procharger was set at 3lbs. So I'd say around 600hp? Never got a build sheet or previous owner never dynoed.
When I ran my slip #s, it came in around 17percent, which I believe I can get it down.
The current prop is a 29p hydromotive, and after talking with bblades, going to try a 30 or 32 bravo I this spring after doing some mods to the carb/intake/heads/procharger/fuel system setup currently. A similar set up on a boat that was for sale a while ago had 675hp and ran 88mph..so I figure I should be damn near that this spring..hope so
Drock78
12-27-2012 03:03 AM
Depending on heads but I would bet your over 700hp Mike
