22' tantrum huh?
01-08-2014 | 12:47 PM
#11
Registered
Joined: Oct 2000
Posts: 3,528
Likes: 10
From: Pompano Beach, Florida
We are going to use the 22 mold we have designed and built with the patented DDC hull. However the deck will be a smaller version of the big boats. You get three power options: outboards, outboards or out boards.....
01-08-2014 | 12:56 PM
#13
Registered
Joined: Oct 2000
Posts: 3,528
Likes: 10
From: Pompano Beach, Florida
Actually the 31 CC was, in fact, dammed right at the transom to create the original 28. This was in 1999. The 31 included the 'engine bracket/ swim platform' in it's LOA.
In 2004 we decided to pull a part from the AT 32 V-bottom mold so from then on it was a different bottom. You could say we dammed it. The interesting part was that the lifting strakes actually worked a little better than the original '28/31' mold since we didn't touch the lifting strakes.
The 29 will be a new mold with the DDC patented hull.
If you tried to dam the 28 ,old you would have incredibly unproportional hull sides.
In 2004 we decided to pull a part from the AT 32 V-bottom mold so from then on it was a different bottom. You could say we dammed it. The interesting part was that the lifting strakes actually worked a little better than the original '28/31' mold since we didn't touch the lifting strakes.
The 29 will be a new mold with the DDC patented hull.
If you tried to dam the 28 ,old you would have incredibly unproportional hull sides.
From the man himself
http://www.offshoreonly.com/forums/a...ml#post1954419
So the 31 CC was blocked down to create the original 28, and the 32 was blocked down to create the revised 28. But I am wrong in assuming that you could make a 22 by blocking down the 28?
http://www.offshoreonly.com/forums/a...ml#post1954419
So the 31 CC was blocked down to create the original 28, and the 32 was blocked down to create the revised 28. But I am wrong in assuming that you could make a 22 by blocking down the 28?
01-08-2014 | 01:29 PM
#16
Registered
Joined: Aug 2011
Posts: 289
Likes: 0
From: RI
Any idea where the first 28 is at now? I am guessing by my hull ID that I may have the 2nd 28 that you guys produced. ATD28V02
01-08-2014 | 02:04 PM
#17
Registered
Joined: Aug 2011
Posts: 433
Likes: 0
From: Crane Hill, AL
Testing and tuning by some using the chuck a dam anywhere in the mold technique:
http://www.youtube.com/watch?v=ygB3mjP5N7g
http://www.youtube.com/watch?v=ygB3mjP5N7g
01-08-2014 | 05:43 PM
#18
Registered
Joined: Feb 2011
Posts: 769
Likes: 0
From: Brookfield Wi
01-08-2014 | 06:28 PM
#20
Registered
Joined: Jan 2006
Posts: 4,951
Likes: 3
From: Syracuse N.Y.
I assume that it is the Banshee then. If and as you said a new deck, will it have a bit more freeboard? Can't wait to see this.
