What is the fastest 29 Outlaw you know of?
#41
Registered
Join Date: Jun 2004
Location: Indianapolis,Indiana
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
I've throttled my 36 with my eyes closed for 3mins.Oyeah and still had a podium finish.... I'll crack open anyones bronco baja if they need some help......................
Last edited by jgrayson; 04-04-2007 at 08:36 PM.
#42
Registered
Thread Starter
Out back, I put on 12" IMCO extension boxes, IMCO extreme drives with 3" shorties.
Tyler says I'll be at 650 a side @ 5lbs of boost & I've got pullies to push her up to 750 but I don't know that I'll run them except for special occasions. That high octane sh!t is high dollar!
Christian, I might hit ElDorado? Tim is letting me use his place to stab the motors. Hope to so that Thursday afternoon or Friday morning.
#43
Registered
Join Date: Jun 2004
Location: Wichita, KS
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
Let me know if you need help. I am finishing the paint on the PQ this weekend. MY slip is empty at Eldo if you need a place to work etc just drop the lift and have at it.
#44
Gold Member
Gold Member
Join Date: Oct 2001
Location: Haslet, TX,USA
Posts: 1,936
Likes: 0
Received 0 Likes
on
0 Posts
#46
Registered
Thread Starter
Motors are done & going in today! Of course I'm posting this @ 1:00 a.m. CDT. I'm pretty much f*cking tired of working on this boat!
Christian, thanks for the offer. I may take you up on that.
jryan....I don't know what to say about you? I like your style!
Christian, thanks for the offer. I may take you up on that.
jryan....I don't know what to say about you? I like your style!
#50
Registered
Thread Starter
I'd like to say it is going good, but it sure is not! I've had to fabricate way too many parts to count. Partly because I'm anal about my stuff looking right & partly because there just ain't any other way to make it work than to make my own parts. Oh & tools.
Tonight I worked on ligning up the drives to the couplers. One motor went fantastic, one I just gave up on tonight. Had to make 2 wrenches to fit the motor mount nuts. Snap-On will watrranty sut up & welded on 1 1/16 & 1 1/8 wrenches. Right?
I'm planning on firing the motors today. Just have to figure out how to make the throttle linkages work.
Tonight I worked on ligning up the drives to the couplers. One motor went fantastic, one I just gave up on tonight. Had to make 2 wrenches to fit the motor mount nuts. Snap-On will watrranty sut up & welded on 1 1/16 & 1 1/8 wrenches. Right?
I'm planning on firing the motors today. Just have to figure out how to make the throttle linkages work.