Offshoreonly.com - Baja Owners: Plans For 2009

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Baja (https://www.offshoreonly.com/forums/baja-31/)

- - Baja Owners: Plans For 2009 (https://www.offshoreonly.com/forums/baja/201763-baja-owners-plans-2009-a.html)

Def keeping my boat. I can't stand the new emblem. I never had a problem with the fountain circle till it was matched with the baja emblem. I think it looks tacky.

Quote:

Originally Posted by Zoom3 (Post 2888581)

Just put full hydraulic steering in the boat this spring. it's like a whole new boat !!

How tough of a job was that? And about how much did it cost you? If you mind me asking. (PM would work if you want)

Any new players for this thread?

ok i will play. i am picking up a new to me 250 es on monday.

Quote:

Originally Posted by bobbowobbo (Post 2831547)

two fresh overhauls (stan and ollie), upgraded breathing components from 3x8 flame arrestors performer rpm intakes a couple of Bob Madara's cam setups, 496 exhaust and 4" angled thru the transoms to shut the cops up. just finishing a custom dash/new gauges so I can mount the 8" chart plotter.
I cannot wait
Bobbo:ernaehrung004::ernaehrung004:

turns out I can wait.. but I'm gettin reeel close I have an hour of breakin on both engines, the dash is in with a bit more wiring to go and I just got done prepping the rings for the exhaust. I ended up with comp cams (they answered their phone) roller rockers springs etc.. I ported the peanut heads simply for the challange. and the 496 takeoffs. some guy Moroso stopped by because Harland Sharp did earlier.. all American, All purchased local... all accomplished by yours truley.. with a litttle help from my friends.

I think I just uploaded a pic of stan, I will post further pics sooner than later they both are in fact in I just have not been taking pics

I will see you in port austin at the end of july, and holland in a week or so
Bobbo:ernaehrung004::ernaehrung004:

Looks good! I would love to see more pics of your boat... not too many of these around anymore!

a few pics I found

I found a few more pics, been busy with the rest. hopfully final welds on the exhaust tomorrow he he

you may notice the change in the plumbing from the first pic.. I learned something about my new exhaust

what's the deal with exhaust plumbing???

Quote:

Originally Posted by Full Force (Post 2916952)

what's the deal with exhaust plumbing???

there were checkballs in the original fittings restricting the flow from the thermostat water, I just ran the thermo water straight to the bottom and the bypass I T'ed into the risers

Just noticed the thread. No new boats in the works for me. Mine still looks like new, I have my own building now and no longer have to pay for storage:evilb:. This spring I upgraded to a roller cam from RMbuilder and gained 5MPH, plus the boat just runs better, quicker, idles better. This winter my neighbor and I are installing a custom ram air system. I would like to get a -3 box, -2 shorty or maybe just have the transum recut 3 inches higher.