Yea, that isn't such a good idea. I'm out of practice.

Up to two pages in just 4 hours:drink:

So, I'm going to go get the boat & put in some fuel pump relays today & hopefully get it all back together by Friday for a run down here on Cedar Creek.
Let's hope all my parts get here today.

i'll be looking for a new thread from u about broken (insert item(s) here).

:kiss:

Here I'll spice it up, how about some procharger help??? I'll copy&paste http://www.offshoreonly.com/forums/d...er-3-5psi.html


hey guys, newbie here to OSO, need some fuel system help with my 05' 496HO b1x w/140hrs. I have a custom 3.5psi Procharger on my 25OL, custom because I relocated it. In the OL from the center of the crank pulley to the stringer is 16.5", the stock procharger sits 19"-20" off the motor, that would have meant alot of cutting, no thanks. So I relocated it above the stringer and used a 68" belt, works good so far with no cutting. Anyhow I need advice on a fuel system and ECU, does the ecu need a reprogram for low boost setups? I'm staying with low boost, I don't have alot of faith in the 496 so until I tear it down and throw some forged stuff in, it'll be 3.5psi for now. The 05' 496's have the cool fuel box with the pump, filter, separator, and cooler all in one with no return line, is this useable? or scrap it? I hear the ATI regulator is trash too, so I need advice on pumps, regulators, coolers, and fuel rails if I need them. I've got a water pressure, fuel pressure, boost and a EGT gauge along with the procharger. Here are a few pics of my OL and procharger build. Thanks fellas. Stan.
Attached Thumbnails

I noticed that this place has been pretty slow too. So is SO Baja section. I haven't check TBM in quite a while.

I did Desert Storm Poker Run a couple weeks ago! :coolcowboy::cool:

Going to race in the Rum Run in July.

Oh, got a new aluminum swim step for my boat. Freshly powder coated and ready to go. Hope to get it on in the next couple weeks. Anyone want a fiberglass one?

Replace cup holders with new aluminum, except for the passenger front one. Have to remove the grab handle to make enough room to slip in the cup holder. The handle is blind screwed and I'm a little hesitant to pull off the padded side panel to gain access. Don't know if it's just glued on or what.

What else? Oh, polished my props again.

That's it!

I put some labbed 26 Bravo's on the boat, just need some motors to spin them now. . just kidding they are doing fine.

Pulled the swim platform off the boat and replaced my steering hoses. Sun is hard on parts, swim platform was turning pink and the hoses were wrecked. Guess I should get a longer slip at the next place. Going to try white on the platform this time to reduce the sun fade and make the boat look longer! :drink:

LIFE SUPPORT:eek:

Please don't pull the plug!:evilb:

Off topic, but since were keeping it alive... What would two 496 mag ho be worth with 110 hours. They are in my 2006

$5K each