OK, Dave

I broke-out the 2010 calendar and penciled your name in for April.....I am going to hold you to it.

Dave

You can take that to the bank Dave. Hold onto a set of those bolster plastics for me I need mine replaced where it locks in.

Dave or Adam do either of you recall if Baja used a factory mount on the 500efi's for the Latham container? I'm running into a hangup on this and I guess I could fab one if need be, but prefer stock if there is one.

Dave,

I know the Mercury Racing did not provide anything "stock" for Latham steering bottles, but I would probably have to ask Adam where Baja purchased them?
I do remember that when we repowered Doc's 36 the bracket we had for the 525's was not tall enough, and we had to have one fabed. I may still have that 525 bracket, or we gave it back to doc, with all the returned stuff???

XT

I checked with Mark figured he had the one off his 500's, but he didn't recall having it. Be a blessing if the 525 bracket was the same. If so I'll take it if you still have it. PM me the cost on it and I'll send you a check or Paypal for the cost of that and glovebox inserts.

Do you guys have the rubber seal/gasket for those glovebox inserts?

Dave,

Will look around to see if I still have that bracket?

When I went to the vendor on the glovebox inserts last week, they had two of the 33 Outlaw inserts waiting there. After designing most of the doors, I have a pretty good idea what each one looks like, and after they checked the part number again they determined that I was right. They want to know if you could send me your damaged one to determine their correct mold, and they will run a couple new ones since we spent 2 hours looking for the inventory that the computer said they had, but could not find!

Good thing it's winter time, and the boat is tore down right now....

XT-Innovations
4799 Stetzer Rd.
Bucyrus, OH. 44820

I have no problem doing that just don't want to loose it. I'll take it out of the boat and box it and ship it to you. Won't be for another week though as I'm out on the road working and have been for the past 3 weeks...Sucks spending so much money right now with a poor economy it makes you have to work too much.

Be thankful...it could be worse......spending money with no income.

Well that definately wouldn't be happening...I'd be selling rather than buying..

Those brackets came directly from Latham. I am pretty sure the 500 and the 525 brackets were different but probably only due to the length of the offset spacers that went behind the plate that the res bolted to. Just take a piece of cardboard and fab up a template. If you have the res and the engine available it should be fairly straight forward. I can get you some up close photos if you need them. Send me an email adam at saccentimarine dot com.

The height of this bracket was not Mark's issue. It was something they tried to correct the "catch" in the steering.