redwavecrash

Doing a motor swap right now starting on mocking up a hardin sea strainer looking for options on where other people have installed them on their 25 outlaws .

redwavecrash

Should I repost in do your self boating on a budget?

baditude

Not sure what the difference is, but my 24 outlaw is drivers side against the transom flush out runs around corner to side of engine compartment

redwavecrash

Thanks this is the only spot I have found so far that I can put it . Didn't know if it would fit any where else with the motor out its hard to judge

Tom272Baja

My 272 is in the same place.

redwavecrash

Guess it's a go thanks for the replies. Marked the transom lastnight gonna install tonight . Was thinking 3/4 inch long stainless lag bolts should be fine ?

iaoutlaw

Post some pics when your done

redwavecrash

Can I post pics without paying?

iaoutlaw

yep create a photobucket album and post the image link

redwavecrash

Anyone chime in on the size lag bolts I'm gonna use to mount 3/8 stainless 3/4 long?