new member from france
#1
Registered
Thread Starter
new member from france
Hello everyone, I am Lucien I live in France I am 64 years old, I have a baja 250 sport of 1989 , that I have for 25 years and I have restores to his purchase, it is equipped with a motor 502 ci realese last side, I am currently on the preparation of this one! I am also a collector of muscle because 70s and pick up!
thank you in advance for your welcome and sorry for my very bad english
thank you in advance for your welcome and sorry for my very bad english
The following 4 users liked this post by Bajaboat77:
#7
Registered
Thread Starter
i try to rebuild my engine, i have a big block 502 ci mercruiser a carburetor, block boowtie hiperf pass 4 bolts, i give you the casting block number 100511107, it was realerer at 4.530 inches and the crankshaft was rectifying to 0 , 20, I buy JE pistons. ref 338167 pistons, and segments JE s100s8-4530 / 5, eagle forged brand rods for 700 horsepower, I also buy heads of art pro 1 ref 19200032 with admission valves of 2,300 inches and exhaust valves 1,880 inches. These breeches were grinded at 0.40mm, which is 0.01574 inches, because they had a valve accident, I give you all its indications to have advice for the continuation of my reconstruction, purchase of a camshafts, a distribution sets and all that may be suitable for a nice engine I would like to have 600 horses I go back motor full roller thank you in advance for your advice because here in France your boat is not very rependu and for the boat mechanics high performance knows even more complicate thanks again for your reponsent
#8
Registered
Welcome Lucien, If you don't get much for response regarding you engine post a thread in the Technical General Q&A forum that way you hit more than just Baja guys. Post pics once you get a chance.