Besides Eddie Marine,who sells the colored anodized cup holders.The ones EM has are in between the size I'm looking for.I'm looking for an exact size to what I have,if that is possible. Thanks for any help you guys can give.

Livorsi Marine


www.livorsi.com

CP PERFORMANCE

http://www.cpperformance.com/

Livorsi is a little more. I ordered mine from Eddie Marine. Had them at my house in 3 days, California to Ohio. The holders up by the driver and passenger sides I made bigger to accomodate a beverage with a huggie-before there was not enough room for a beverage with a huggie, beverage only. Was not hard to enlarge these with a file. I would think Eddie's sizes should fit your other cup holders without a size issue. I had no problem ordering to size.

Try Rex Marine, the large ones, they give you two options, powder coat or annodized. They are cheaper in price than all of the above and they also have a nice neoprene pad that goes inside the cup holder that sticks to the bottom so your beer or soda can will not rattle around. I think I bought 8 of them for less than $100.00. I shopped around pretty hard prior to purchasing, they have a web site and catalog.

Thanks for the help guys.Looks like everybody carries the same sizes.I guess I'll just have to do alittle carving to get the large ones in.I ordered 4 from Eddie Marine for $40.They seemed to be the cheapest.

Get the cork liner so that it will prevent any rattling of anything in the cup holder. Call them and add it to your order for each cup holder. $1 each. I got mine from Eddie too.

I am having the same problem, the ones in my H2X seem to be an odd size compared to what I can find from Eddie Marine and Rex Marine. Good Luck....

I just replaced the side panel inserts and all the cup holders in my H2X. I had to trim a little with a razor knife, but no problems.

Hammer and h2x should have 2 large and 2 medium, 10.00 on eddie, or Dana marine