thisistank

I took the boat out for a nice little jaunt up the coast on Saturday. Seas were mellow 1-3's with some wind chop. On the way back I'm cruising at like 65-70 and something (plastic that looks like a bottle cap) bounces off the wind screen right over the boat. What the f*ck!? I look over the boat to see if I can see anything and low and behold it was the plastic cap that the window crank handle screws into for the port window. Anyone have any clue where I can get one of these? Thanks for the help.

Steel Outlawed

iTrader: (1)

Are you talking about the hatch handle.

If so you can purchase those from Bomar. I seen this in a thread somewhere else. I will see it I can dig it up and post where I found it.

Steel Outlawed

iTrader: (1)

Here is a link to their website.

http://www.pompanette.com/pompweb.ns...4?OpenDocument

thisistank

All I could find is the screen and screen ring on the link you posted. I'm talking about the piece that the handle screws into. The handle is still attached to the hydrolic ram on the inside of the cabin. But the piece that is screws into is gone. It's the little white cap on the outside of the windows. Fairly flat, round, white, caps. Two on each window on the outer sides of the windows.

Steel Outlawed

iTrader: (1)

Does yours have the square hatch or the hatch with angled ends.

thisistank

I think we have the same hatches. They are square w/rounded ends. One on each side of the deck, just forward of the wind screen. I think I actually found the right part here on the site you posted. I think it's part # 'n'.

http://www.pompanette.com/pompweb.ns...2567c8006b12ea

Steel Outlawed

iTrader: (1)

The handles for mine are the ones labeled L. I just fixed one of mine.

thisistank

Did you loose the cap too? That handle (L) actually looks like mine. I need the cap that goes w/it though but don't see it there. Did you replace the cap too?