Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Chris Craft (https://www.offshoreonly.com/forums/chris-craft-155/)
-   -   Who's Ready for this season? Anyone out?? (https://www.offshoreonly.com/forums/chris-craft/156296-whos-ready-season-anyone-out.html)

HuronRiverRat 04-19-2007 11:10 AM

Who's Ready for this season? Anyone out??
 
3 Attachment(s)
I just pulled the Stinger out of the shop today after working on it all winter. I freshened up the engines, did the interior and replaced the drives with new Sterndrive engineering drives. I have it hooked up and am breaking it in as we speak. If I can get the little things wrapped up this week, I may try a real trial this weekend on the lake. Dan

CCstinger260 04-19-2007 09:33 PM

Dan, that boat's lookin' good. Hopefully I'll get mine together before too much of the season's gone. The wife says it MUST be splashable by August for our Dale Hollow trip:eek: I better get my azz in gear!

Did you go with counter-rotating when you put on those SEIs? I put CR on mine, and it drives way more neutral than my brother's Nova that has both RH rotation. :argue: His is probably 10mph faster though.

psmith 04-20-2007 05:38 AM

1 Attachment(s)
You lookin good dude but your way behind us guys down south.....

psmith 04-20-2007 05:41 AM

1 Attachment(s)
See

ve3lt 04-24-2007 07:29 PM

We had a glorious weekend for weather in Ontario. I got my boat wet and had a great ten minute ride!!!

Seems that my impellor went on the starboard engine and it started to overheat, so I shut it off and nursed it back to dock with the port side engine only.

hrumphhhhhhhh. time to turn the wrenches again?

Full Force 04-24-2007 09:34 PM

Looks good Dan, I am trying to get my new engine together this week, I hope for good results, I am rigging a BBC oil cooler to the limited this year too, lots of new things going on here this year!!

I will be calling you soon, I saw the docks are in at your place.

psmith 04-26-2007 05:37 AM

About two hours after that picture I dropped the port engine, new engine being painted today will make thunder this week end, hang in there boys it will be warm up there one day......

HuronRiverRat 05-02-2007 08:09 AM

I had the boat out over the weekend. It ran great. I installed a set of the bennet trim tab indicators over the winter and it helps you keep track at all times of where your tabs are at. I would reccomend installing them If you are thinking about it. Now that my trim gauges work and with the trim tab gauges installed, I can really tweak the boat to its full potential. Dan

Full Force 05-02-2007 03:37 PM

Dan, do you have a schematic on the trim gauge, mine was wired all messed up and I want to get it working, any info?

ve3lt 05-10-2007 08:55 PM

Impellor is fixed and took it out for a short swirl around the marina last night. Boat is loaded on trailer ready to go home to my home port, and I will be tearing up the open water this saturday...can hardly wait! :D


All times are GMT -5. The time now is 12:00 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.