Winter project '02 TG - DONE!!!!
 

This weekend I'll put a few more touches on the TG. But for the most part I am DONE. I do have to say the boat looks like "my" boat now, and it looks 95% like a new boat off the showroom floor. Here is a list of what has been done and a few pics:

Replace throttle cables w/ supreme 33C
Replace Trim Tab cables w/ supreme 33C
Paint rear rails and rail supports around hatch
Paint front rail
Refinish rail spacers
Paint bolster bases w/ red to yellow fade
Paint grab handles w/ red to yellow fade and "Cig" logo Paint dashes done by Mitcher-T
Gauges gedone f/ Platinum to chrome super bezels
Replace Garmin 185 w/ 192C
Replace purple bezels w/ new ones
Replace circuit breaker covers w/ new
Replace switch boots w/ new
Re-caulk diamond plate
Remove lousy Alpine amp and install old school Soundstreams
Replace cabin door gasket
Fix stbd side panel - was loose
PowderCoat rear seat degree brackets
PowderCoat rear vent on engine hatch
Powercoat screens on engine hatch
Paint underside of wind deflectors w/ graphic
Paint trim tabs - added slight graphic
Detail outdrives
Paint all paint chips
Re- Clear hull sides
Buff FG in cockpit
Install hatch gasket
clean up stereo wiring
re-do trim indicators - added springs & index
Replace Spark Plugs
Replace cap & Rotor
Replace horn
Fix FG for head hinges
Replace float switch covers
Refinish large fuel valves access hatch
Bezels on cup holders - waiting f/ Bezels
Bezels on small hatch’s in motor box
Install Documentation #’s
Install Head
Replace bent hatch keeper
Put protective paint film on bolsters base
Check Drives for alinement
Repaint throttle/shifter bases - Mitcher-T
Clean forward bilge's
Clean carpets
Have red trim installed on cabin seat cushions
Replace blower hoses in bilge
Replace cockpit carpet
New cockpit cover
New Mooring cover - both done by Sunrise Uph
Add filter for air intakes
Re-do embroidery "Top Gun" logo on bolsters
Re-Do embroidery "Cigarette" logo above door.
Add threaded brass inserts in dash and glue in.
Re-Place speakers
Re-Place cockpit lights
New CMI Headers
New Starter port motor
New ring gear on stbd flywheel
New Odessey Batteries
Plus alot of little nic - nack stuff that was done "on the fly" and I simply can't remember.

Whew! That's about 99% of it.

Re: Winter project '02 TG - DONE!!!!
 

One more of the motors and new CMI's.

I'll take some pics today.

Re: Winter project '02 TG - DONE!!!!
 

Job well done! That boat looks greattt!!

Re: Winter project '02 TG - DONE!!!!
 

Wow!! What a list.Sounds like you shaped that boat into a 10.
Good luck with it and enjoy.

Re: Winter project '02 TG - DONE!!!!
 

That's quite a list Bill!!!! Are you sure that you didn't miss anything?? :D :drink:

Congrats...The boat looks AWESOME!!!!!

Re: Winter project '02 TG - DONE!!!!
 

I am sure I did miss a few things.
Now that I have this pic of the stern, memory gets a jolt: I replaced the drive shower hoses, checked drive alignment, took apart all the stainless pieces and buffed them out, had the tabs and tab mounts clear coated. . . . . . .

More pics of the motor box. If you look close, check out the shine. :drink: :D :evilb:

Re: Winter project '02 TG - DONE!!!!
 

Now that is a Frenzy shine. The detailers here locally have been SO impressed with Frenzy, our marina now sells the product. But they sell out very quickly.

Re: Winter project '02 TG - DONE!!!!
 

you love that boat :D

Re: Winter project '02 TG - DONE!!!!
 

Sounds like it's a 12 to me !

L.S.

Re: Winter project '02 TG - DONE!!!!
 

Despite the list, the boat was in VERY good condition to begin with. Most (99%) of the items on the list were not necessary, but I wanted to change / update / preventive maintanance things.
Now it looks like a boat I just bought off the showroom and has "my" touches!