fuel sending unit
 

Does anybody have a part number or manufacture for a fuel sending unit for 1993 top gun fuel tank or a good place to start looking.

I just put a Wema sender in my Mistress. I don't think you'd have much luck with the same make/model of sender, you're talking nearly 20 years. Most have the same ohm(resistance range). It was an easy replacement. Disconnect all the batteries, remove the sender, measure to the bottom of the tank, buy a sender thats about 1" shorter, and re-install. Remember you're dealing with a tankful of gas, so use all due precautions.

I measured 16.5" to the bottom, but bought a 14" sender for two reasons. First, it was all the store had at the time, and second, the V is very sharp in the bottom of my tank, so if the sender goes all the way to the bottom, as the tank gets low and the lever starts being in the V, it's measuring a smaller amount of fuel for a given level. Maybe I just am rationalizing my impatience.

Good luck.

Livorsi, about 55$ each.

I put a couple of these in the Bullet a few years ago.


http://www.hardin-marine.com/Instruc...vel_Sender.pdf

What size sendors (how long), did you get for your bullet? I need to replace mine as well. Thanks Jason

Jbraun2828
 

Try a company out of edgewater Fl called Centroid Products. They used to supply cigarette with there sending units. The lady I talked to has been there over twenty years . I just got two sendings units for my top gun part # CGF-24 They will cut the tube to lenght and is already calibrated.Tel # 386-423-3574 or Rex Marine has them but you have to cut the tube

Thank-you

Looks like I ordered the 12 inch version. It's not perfect but I think it's much better than a float sender. Only problem I had was getting the old ones out, those little screws seemed like they were welded in there!

got mine from them also .make sure to tell them you want delay added .it will stop the gauge from bouncing all over the place .i gave her the # on my send units and it had dly on it and she said it ment delay added