Tiger upgrades
#51
VIP Member
VIP Member
Thread Starter
Oh joe, put the teague billet caps on your xrs, they are pricey but i feel they are one reason my xrs lived so long as well as drive showers.
#52
mine are 509s with cnc afr 335s. 741 cam with dual swap (8.1 firing order) 8.6 compression, with the 4.0 litres and 8 lbs boost... Most estimates are 900-1000... Bob Madera said i could fall face first into 1000 if i tune it properly.
i like the looks of the hardin and the way you painted them.
i like the looks of the hardin and the way you painted them.
By the way love the little cig, that's going to be a fun boat, would love to have one...
#53
VIP Member
VIP Member
Thread Starter
I sold my transom assemblies and uppers to offset the cost of the new imco transom assemblies and scx uppers. Dave sat down and figured up a pkg deal that benefitted us mutually and the deal was done. The people on the bay are lucky to have an honest reliable shop so close. Im not the least expensive shop for what i do but i offer quality and fair business and i look for the same in who does my work. Quality is worth it.
Both boats will be up in NE this summer...
dont underestimate your xrs, unless youre launching it all the time. They likevt stay in the water and run well deep.. high x dims are what kills them.
Both boats will be up in NE this summer...
dont underestimate your xrs, unless youre launching it all the time. They likevt stay in the water and run well deep.. high x dims are what kills them.
Last edited by offshoredrillin; 04-05-2015 at 06:24 PM.
#55
VIP Member
VIP Member
Thread Starter
I should be, in the eve on thursday.
#56
VIP Member
VIP Member
Thread Starter
Just got back from MDG, Santa IMCO dropped off toys just this morning... moving right along
Last edited by offshoredrillin; 04-17-2015 at 02:31 PM.
The following users liked this post:
H20W8STER (11-23-2022)