|
Originally Posted by RebarBox
(Post 4575355)
81 mph with 750hp at 5400 rpm and #3s.
what pitch and style prop and what is your drive ratio. What kind of slip will good on these 3 blade cleavers |
Originally Posted by Blackmagic94
(Post 4575421)
what pitch and style prop and what is your drive ratio. What kind of slip will good on these 3 blade cleavers
|
% of prop slip. What rpm did you hit to hit that speed
|
15% slip on your run.
My bravo one drive with a 26p labbed cutting edge 4 blade gets 12% at wot and 21-25 at Econ cruise. I would think labbing yours could cut the slip down and get some faster numbers. |
Originally Posted by TENSION
(Post 4575255)
He must run that in shallow water, he's ground the skeg's right off..........
|
Originally Posted by Blackmagic94
(Post 4575425)
% of prop slip. What rpm did you hit to hit that speed
As stated in previous post - 5400 rpm. Good Luck! |
Originally Posted by lucky strike
(Post 4575461)
Back in the day they would cut them off on the open class race boats to gain some mph.
Didn't that have something to do with the Michelob Light barrel rolling back in the day.. Jr. |
Originally Posted by lucky strike
(Post 4575461)
Back in the day they would cut them off on the open class race boats to gain some mph.
There was a engine package offered back in the day, the K-600, that came with the skeg removed. That must have been thrilling to run without some type of rudder. |
Originally Posted by J-Bonz
(Post 4575468)
LS,
Didn't that have something to do with the Michelob Light barrel rolling back in the day.. Jr. |
| All times are GMT -5. The time now is 11:03 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.