Wow, it is looking killer! I didn’t realize there was another gun running around without the liner. Seams there is a lot to gain by doing so!

There’s a few out there I believe. Problem that I have found with the liners is there is just not many places of contact for tabbing it into the hull. Hopefully it runs well lol. Happy the sorry work is coming to a end lol

Thanks for the YouTube posts. Lots of progress. It looks great! LOL were all eager to see the front bulkhead. Will you fit the dash panels, and then both paint and wire up gauges before you install them?

Yes I will get them fit and mounted make sure o have them were I want them and then paint. I will assemble them outside the boat gauges and such) them put the wiring on a few weather pack plugs then install. I’ve already had them in once I have the bulk head made already it’s been in and out a few times for fitting. It was nice having it out and having the cabin open for ventilation when glassing and doing the gel coating !!! I’m real excited to have those pods in and that wrapped up

Can't wait for a ride!!!!!

Yea me neither …………. Spending this week doing body work to the molds getting them all ready for primer and final fitment

https://cimg4.ibsrv.net/gimg/www.off...2cf944ae6.jpeg
All done with glass work !!!!!!
https://cimg7.ibsrv.net/gimg/www.off...87aa28142.jpeg
Cleaned and moped !
https://cimg9.ibsrv.net/gimg/www.off...11105c66a.jpeg
Glassed in bulk head
https://cimg1.ibsrv.net/gimg/www.off...22b977c77.jpeg
New floor is 3/4 marine ply with 4 layers of 1708 on top and 2 on bottom!! No flex here !!!

https://cimg8.ibsrv.net/gimg/www.off...54371d029.jpeg
Time to start fitting pieces !!!

I have a new floor section made to put in we’re the old one is for know just not going to drop it in till I’m done fitting done want to ruin it. It’s all cut and glassed with gel. I used a non skid came out nice it meets right up to the new permanent front piece

That`s going to make it hard to get in the cuddy .