Grab Handle Removal ?
10-09-2018 | 08:21 PM
#4
Gold Member
Joined: Jun 2006
Posts: 5,119
Likes: 960
From: Seaford, VA
I was able to cut a small holes in my seat bottom and reach up there with a pneumatic wrench and get them off. It was a terrible job for something that seems like it should be so simple. I'd rather pull motors in a snowstorm while wearing a speedo than go through that again
10-10-2018 | 09:24 AM
#6
"Unregistered Gun"
Joined: Dec 2005
Posts: 1,423
Likes: 225
From: Paducah, Ky
Its has either 6 or 8 screws holding the bolster to the base, then one 3/8 lag bolt with a block screwed to the side. When I flipped my bolster over, the seat bottom holes had like a mesh screen over them and was attached by a couple screws. You can remove them so you can gain access to the handle nuts, I used a open ended ratcheting wrench. Watch out for the staples in there! They can eat you up!!
Last edited by Jim Diesel; 10-10-2018 at 09:27 AM.
