Hatch ram relocation?
#1
Registered
Thread Starter
Hatch ram relocation?
I installed new motors but the hatch ram is running into the new headers when we lower the hatch. What are the options for a workaround on this?
Thanks!
Thanks!
#3
Registered
Thread Starter
#5
Registered
Can you run a pair of rams at the sides of the compartment like in the 42?
#6
Registered
Thread Starter
#7
Registered
Not a cig but I’ve been looking into relocating my lifts as the hatch does not open very wide on a ZR. Cig basically took two of your lift mechanisms and put them on either side on the staggered boats. Ingenious design in my opinion. Not a simple quick project but could be done yes. I’m sure replacing the headers now would be a bear. Other option would be to put electric lifts towards the front of the engine bay that push straight up on the hatch, but not sure if you have the room and those can impede access.
Last edited by IGetWet; 03-21-2021 at 05:17 AM.
#8
Registered
#10
Registered
Thread Starter
Not a cig but I’ve been looking into relocating my lifts as the hatch does not open very wide on a ZR. Cig basically took two of your lift mechanisms and put them on either side on the staggered boats. Ingenious design in my opinion. Not a simple quick project but could be done yes. I’m sure replacing the headers now would be a bear. Other option would be to put electric lifts towards the front of the engine bay that push straight up on the hatch, but not sure if you have the room and those can impede access.