Rocker to Toggle Switches
08-05-2004 | 04:04 PM
#6
Charter Member #71
Joined: Oct 2000
Posts: 924
Likes: 14
From: Phoenix, AZ
Re: Rocker to Toggle Switches
LS
It wasnt hard to do, the biggest thing was filling the old panel mounting screws and re drilling. The new panel screw holes didnt quite line up. Then just disconnect the old and re connect the new.
One important thing!!!.....request screw type terminals if you have them...they would normally supply push on, and I didnt want to re do all my term ends. Lucky I asked..they had to order them special. I'll take some pics this weekend
These guys said they do Livorsi's work.
Dan
It wasnt hard to do, the biggest thing was filling the old panel mounting screws and re drilling. The new panel screw holes didnt quite line up. Then just disconnect the old and re connect the new.
One important thing!!!.....request screw type terminals if you have them...they would normally supply push on, and I didnt want to re do all my term ends. Lucky I asked..they had to order them special. I'll take some pics this weekend
These guys said they do Livorsi's work.
Dan
08-06-2004 | 10:39 AM
#7
VIP Member
Joined: May 2001
Posts: 148
Likes: 9
From: Lakeland, FL
Re: Rocker to Toggle Switches
www.mcaster.com has them and you can order red or white rubber boots. I did mine using aluminum
and put the switches how I wanted them.
and put the switches how I wanted them.
