aeo marine "magnum" on ebay
#1
aeo marine "magnum" on ebay
Aero Marine "magnum" on ebay? These are not real magnums right, clone molds made in MI I always thought? Nice boat with twin small blocks though anyone have any info on this boat? Thanks.
http://www.ebay.com/itm/Magnum-Aero-...wer_Motorboats
http://www.ebay.com/itm/Magnum-Aero-...wer_Motorboats
Last edited by uncledad; 02-07-2015 at 04:29 PM.
#3
#5
Registered
Was the Aero that made Browning Boats? I know they were based in Michigan. We had a Browning Mustang II with a 165 hp Mercruiser -- WONDERFUL boat-- and on the rear it did state Aero
just wondering
3pointstar
just wondering
3pointstar
#6
Banned
iTrader: (9)
its up here on the classifieds to. IMO the motors look to be 1986 - hull is advertised as a 1985. The outdrives 4 sure are pre alpha in which IMO are Mercruiser R drives, they are not alphas but are pre alpha outdrives. Outdrive serial #'s will tell exactly as they are either R or if not MR outdrives. Its one of these. 1985 had alpha one hooked to small blocks and of course 454's to. .
Last edited by BUP; 02-08-2015 at 10:44 PM.
#7
Gold Member
Gold Member
It's a Klem Gem made in Michigan by Jim Klem. Left sitting in a field open for many years, if you hit the stringers with a hammer it goes THUD. Originally rigged by Klem with twin Stern Power drives & two very used big block Chevy's.
#9
"Originally rigged by Klem with twin Stern Power drives & two very used big block Chevy's"
What are the cutouts on the rear deck for? They almost look like they were cut for clearance of exhaust from a single big block? Is it possible this was a single at one time? From this pic the stringers don't look original either?
What are the cutouts on the rear deck for? They almost look like they were cut for clearance of exhaust from a single big block? Is it possible this was a single at one time? From this pic the stringers don't look original either?
Last edited by uncledad; 02-09-2015 at 05:53 PM.