Has anyone done this and what kind of costs are involved. Who is best to do the work. Just wondering what it would take to have it done to a 30ft. Any perfromance gains handling and speed has anyone seen from this type of work. I think it woild be ideal to have the tweeked just right and run low power. I live in the northeast

My boat with 4 ft level is not perectly flat. there is 2 curves in, about 1/16 inch in the 4 ft secton 1 ft up from the vee. One spot is a little worse, looks like some kind of touch up.
Anyone in pa Nj do this kind of work or is this minor. Iwill run it for now but in the future i may really try to dial in my boat. Both sides seem to be the same. Manufactures should fine tune there bottoms out of the mold, it would be pretty simple at that point.

What boat are you working with and what year?

I hate to say this but you really need to go to www.seriousoffshore.com and post this in there fiberglass section and talk with OFFSHORE GINGER or GLASSDAVE, because you can post pics and get PM'S for free and for piece of mind if anything just check them out . I have to say that there Tec section is getting better all the time because of the people they have on it who have a vast amount of experience & knowledge from doing fiberglass repair over the years .

allicat when i first read your thread in your first post i thought you were a Cat owner .

Alli,

I answered your question in the other section.

Jamie / Lakeside
.