New Project - Need help estimating design and materials
11-30-2010 | 09:20 PM
#22
Charter Member #232
Joined: Oct 2000
Posts: 18,417
Likes: 6
From: Carlisle, MA USA
2lb is probably what was in there that you took out. Like dave said no way you want to go with 8lb it will cost a fortune. 14 pound you can almost tap it is so dense.
__________________
Put your best foot forward!
Put your best foot forward!
12-06-2010 | 09:30 PM
#23
Thread Starter
Registered
Joined: Mar 2003
Posts: 3,080
Likes: 81
From: Fort Worth, TX
I finally hit dry wood..... at the dash!
I am going to add a real bulkhead here and start working back. The foam came out in huge 1-2ft pieces until I got to the dry stuff. I used a long piece of aluminum flat bar like a butter knife. I drove it into the foam and worked it to each side to cut large pieces.
Hopefully a full day of sanding and squaring off, and I will be ready to start in the other direction.
I am going to add a real bulkhead here and start working back. The foam came out in huge 1-2ft pieces until I got to the dry stuff. I used a long piece of aluminum flat bar like a butter knife. I drove it into the foam and worked it to each side to cut large pieces.
Hopefully a full day of sanding and squaring off, and I will be ready to start in the other direction.
12-15-2010 | 04:51 PM
#24
Registered
Joined: Jan 2007
Posts: 6,487
Likes: 361
From: Mansfield, TX
Nice progress.
I saw this arneson drive for sale and your project was the first thing that came to mind. http://www.lakepirates.com/forums/in...0&#entry367526
SLEEPER!! yeahaw.......LOL.
I saw this arneson drive for sale and your project was the first thing that came to mind. http://www.lakepirates.com/forums/in...0&#entry367526
SLEEPER!! yeahaw.......LOL.
