Ok got drive off....Videos included.... Whats wrong?
#1
Registered
Thread Starter
Ok got drive off....Videos included.... Whats wrong?
Sorry post with videos moved here http://www.offshoreonly.com/forums/d...ched-help.html
Last edited by FuelinAround; 04-25-2010 at 05:24 PM.
#3
Registered
Thread Starter
Check out videos on other thread I screwed up the html and never knew I created this one. The drive will not even shift when the sifter cable is unattached.
#6
Registered
Thread Starter
There is a good video of it on the other thread http://www.offshoreonly.com/forums/d...ched-help.html
#7
Registered
Join Date: Jul 2008
Location: Cinnaminson, NJ
Posts: 305
Likes: 0
Received 0 Likes
on
0 Posts
From what i am seeing, you haven't pulled the drive off the boat yet. The shifter cable in the gimble housing may be butchered up or even broken. You need to pull the drive off the boat to see if this is your problem.
#8
Registered
Join Date: Dec 2009
Location: Grain Valley,Mo
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
I had a similar problem cable broke it would go in reverse but would not do anything else. You can switch the cable pretty easy back nuts off pull gear houseing back about 3/4 to 1" just enough room to see what is going on just make sure all o rings are in correct place after slinding new cable thru the cable bellows have a partner with you they are not heavy but not that light either
#10
Registered
Join Date: Dec 2009
Location: Grain Valley,Mo
Posts: 867
Likes: 0
Received 0 Likes
on
0 Posts
Go to you a manual called Seloc mercruiser stern drives it is like a hanes or chilton manuel gives step by step. Also a Mercury Mercruiser #28 service manual I have both very helpful on just about everything under the engine hatch Got mine on ebay but sounds like you need help asap