|
Originally Posted by fkboatman
(Post 3408731)
I hope for your sake, that is a roller cam in that motor. Non roller cam needs 1500 rpm break in for about 20 min. with a break in oil...... sounds good.
It's roller |
Sounds great Dave, turn your idle up a bit. :coolcowboy:
|
Originally Posted by HaxbySpeed
(Post 3408882)
Sounds great Dave, turn your idle up a bit. :coolcowboy:
|
That's good, it sounded quite a bit lower in the vid. As long as your shift interrupt switch is adjusted properly it'll work fine. Have fun out there!
|
Had it on the water today and runs good. Acceleration is awesome!!! Didn't run it to hard because it's still fresh but I believe it's gonna be one stout small block.
|
| All times are GMT -5. The time now is 03:10 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.