1.50 to 1.36 74 mph boat...
#21
Registered
iTrader: (1)
Yes I was buying them (actually did), they came stock on the identical boat 91 instead of 94 with slightly less hp 385 vs 415. Have all new bearings, seals, etc. They are mint, thanks (Nordic95).
Yes, 100% gps, it's usually in the 73 range but the props are kinda sh1tty.
Pics are 1.36 drive(s), gps and damaged 28's
Yes, 100% gps, it's usually in the 73 range but the props are kinda sh1tty.
Pics are 1.36 drive(s), gps and damaged 28's
#22
Registered
Thread Starter
Join Date: Mar 2005
Location: Mine Hill, NJ/Lake Hopatcong, NJ
Posts: 1,266
Likes: 0
Received 0 Likes
on
0 Posts
Mine has maybe touched 70 & I've only got 26 mach drivers, which are a round ear prop, I have been wanting to try some new props but have a twisted prop shaft I need to take care of. I don't think I could come anywhere near turning 28's!! What is your cruising speed @ 3,000rpm's, I'm in the low to mid 40's
What motors are you running?
#24
Registered
Thread Starter
Join Date: Mar 2005
Location: Mine Hill, NJ/Lake Hopatcong, NJ
Posts: 1,266
Likes: 0
Received 0 Likes
on
0 Posts
#28
Registered
Thread Starter
Join Date: Mar 2005
Location: Mine Hill, NJ/Lake Hopatcong, NJ
Posts: 1,266
Likes: 0
Received 0 Likes
on
0 Posts
#29
Platinum Member
Platinum Member
Caution:
If the 1.36:1 drives are "untouched" 1991 drives, you need to plan on a cone clutch upgrade. The pre 1990 drives are 3 rib clutches, and 1992 ish they went to 6 rib. Those drives may or may not have the 6 rib clutches in them already. The upgrade is not expensive, and needs done as SOON as you detect a slow shift or clunk when shifting.
MC
MC
If the 1.36:1 drives are "untouched" 1991 drives, you need to plan on a cone clutch upgrade. The pre 1990 drives are 3 rib clutches, and 1992 ish they went to 6 rib. Those drives may or may not have the 6 rib clutches in them already. The upgrade is not expensive, and needs done as SOON as you detect a slow shift or clunk when shifting.
MC
MC
#30
Registered
iTrader: (1)
Just put complete rebuilt from bottom up motor in a couple months ago & had the top end redone on the other last spring. Boats always been an @ best 70mph from the day I got it almost 4 years ago!! My hull actually has a small factory hook in it, does yours?
You being @ or near sea level prolly helps quite a bit? The #'s your running are actually very typical or better than the stepped hull 32's w/ same power
You being @ or near sea level prolly helps quite a bit? The #'s your running are actually very typical or better than the stepped hull 32's w/ same power