Mounting 24 x 3 inch oil cooler on rear of block
#12
Registered
Platinum Member
wow,,,now i am thinking about remounting my coolers to back side of motors.
as mine mounted to the center stringer.
they are VERY VERY hard to get to.
i have just upgraded to the thermostat controlled 3 x 18.
but ,,i guess ,,why would you ever have to access them???
i mean it would be nice,,,but,,,,,,,,,,,there is only so much room
engine compartment is very very tight
wish i had staggered motors.
............
these are old coolers both 2 x 15
as mine mounted to the center stringer.
they are VERY VERY hard to get to.
i have just upgraded to the thermostat controlled 3 x 18.
but ,,i guess ,,why would you ever have to access them???
i mean it would be nice,,,but,,,,,,,,,,,there is only so much room
engine compartment is very very tight
wish i had staggered motors.
............
these are old coolers both 2 x 15
Last edited by flashgordon; 05-19-2019 at 10:37 AM. Reason: spelling