5252 EFI Flush Pro
 

Has anyone had a positive, negative or any experience with using a Flush Pro kit with 525 EFI's? I'm adding Whipple's to the motors and I would like to put these on however I'm a little concerned about water restriction.
Thanks
Rick

https://cimg4.ibsrv.net/gimg/www.off...12457c42d0.jpg

I’ve used a lot of them. Usually they last 3 years and develop a crack and leak. Can you put a tee in line with a ball valve instead?

If you’re doing the whipple, you’ll at least want a sea strainer. I’d plumb a flush into there.

That's probably best. There is just so little room in this boat, I have no idea where I could mount the ball valve where it could be reached. Although, if they need to be changed every 3 years that's probably far worse that jimmying a handle. Thank you very much for the input!!

Ya, I'm putting a sea strainer in for each of the MOAC. I would love to put one in for each engine but there is not where to put it that would be accessible.
Thanks
Rick

Maybe on of these

https://cimg9.ibsrv.net/gimg/www.off...63aeb1fd13.jpg

That looks great!! The right engine is no problem. The left side is the real issue. Best picture I hve now the motors are out. https://cimg9.ibsrv.net/gimg/www.off...0866b6e61a.jpg

Have you measured the hatch clearance for the whipples, looks to be close with the efi

According to Whipple the height is only 1" higher than OEM. I at least 1 1/2". So, I sure hope their correct!! :)