When doing Bravo drive service I would grease the splines of the yokeshaft with Merc Spline grease and install the drive.
I'm from back in the days when the coupler didn't have grease zerks.
I want to start greasing from the coupler's zerks from time to time.
Any specific procedure or do I just give the ol' grease gun a couple of pumps and be done with it?

Thanks
Dennis

OK OK
I had some time and did a search.
Looks like I'll still grease the splines before installing the drive.
Then grease at the coupler's zerks until I see grease pushiing out of the coupler.
Try to clean up as well as possible to keep the engine compartment looking good!

Dennis

Thanks for posting your Q&A, I was wondering the same.