Offshoreonly.com - Bravo 1 Oil Pump Adapter

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Drives and Lower Units (https://www.offshoreonly.com/forums/drives-lower-units-217/)

- - Bravo 1 Oil Pump Adapter (https://www.offshoreonly.com/forums/drives-lower-units/223190-bravo-1-oil-pump-adapter.html)

bert4332

01-21-2010 11:08 PM

Bravo 1 Oil Pump Adapter

I ordered a hand pump the other day to use the threaded adapter to put on my sprayer. When I went to make sure it was the correct size I noticed that the adapter doesn't line up 90 degrees to the hole because of what I'm assuming is the thrust hub? I'm looking at the service manual and I can't tell what it is. How is this removed? All I want to do is screw the adapter in the hole and fill the drive. If need I can shoot some pics.

thanx

Mr Gadgets

01-22-2010 04:46 AM

Bert.. post some pics. Worth a 1000 words.. :)

bert4332

01-22-2010 09:01 PM

Here are a few.

http://i276.photobucket.com/albums/k...t4332/hub1.jpg

http://i276.photobucket.com/albums/k...t4332/hub2.jpg

bobsbillets

01-22-2010 09:08 PM

Tap it lightly with a hammer and that washer will come off. It is tapered so its a tight fit.

Mr Gadgets

01-24-2010 10:15 PM

That is correct, it is on a taper and should have some grease on it.. If you use a screw driver to gently pry it off, it should pop right off. Use a piece of wood or something to protect the paint on the edge of the bullet.
Then you will clear access to the drain hole.

Dick

All times are GMT -5. The time now is 03:05 PM.