Slop in gimbal ring
04-12-2010 | 07:31 PM
#1
Thread Starter
Registered
Joined: Jan 2006
Posts: 90
Likes: 0
Slop in gimbal ring
Yesterday when I had my B1 drive off replacing the shift boot I notice some play in the horizontal gimbal pins for the trim. The steering pins seem tight...
Is any play acceptable and if not what is the best method of repair?
Is any play acceptable and if not what is the best method of repair?
04-14-2010 | 06:02 PM
#2
Thread Starter
Registered
Joined: Jan 2006
Posts: 90
Likes: 0
i remove the trim and drive limit switches and found both hinge pins was backed out and flush with gimbal ring....They were both about 2 turns loose!
I torqued them to 150 ft. pds..
Does that destroy the switches since the hinge pins backed out?
I torqued them to 150 ft. pds..
Does that destroy the switches since the hinge pins backed out?
