im looking for the input shaft that goes from the out drive into the tranny. has a u joint on one end that goes into the yoke and then a splined shaft on the other end.. i dont know the proper name i guess and dont even know what to search ... anyone know what im looking for and a good website i could get one from? for a trs drive off a 86 chris craft 390 stinger thanks for any help!

http://www.mercruiserparts.com/Show_...+GEAR+ASSEMBLY

Part number 35 my man, depending on which transmission you have (Merctrans or Borg Warner).

Need to know what tranny you have to know what one you need. They are different depending on if it is a Merc Trans or a Borge Warner.

Jon

Borg-Warner has the splines on the outside of the shaft,externally. Merc Trans has the splines internally and a spring on the end. Here's another place where you can get them, a little cheaper.
http://www.perfprotech.com/store/ass...LY,986-50.aspx

If you need a Borg Warner input shaft I might have one laying around in my garage.

I might have one for a merc trans

Just noticed its for a 390 chris craft stinger. More than likely its the borg warner setup

Just checked, it is for a Merc trans. I had it removed from the new upper that I bought cause I needed the Borg Warner.

Ya a '86 would be a B-W if it's the original set up. One good thing the B-W shaft is 100 bucks cheaper than the Merc Trans one new.

I got two merc style if anyone needs them